Buffalo Wireless-G High Speed ADSL2+ Modem Router Manual do Utilizador descarregar pdf (Página 12)

4. If you have an RJ45 wall jack for your ADSL service, connect an RJ45-to-

RJ11 converter to the wall jack. Then connect one end of the telephone cord

to the converter and the other end to the gray RJ11 port labeled “DSL line” on

the back of your Router.

Powering Up your Router

1. Connect the supplied power adapter to the Router power-input plug

labeled “Power”. Note: For safety and performance reasons, only use the

supplied power adapter to prevent damage to the Router.

2. After connecting the power adapter and the power source is turned on,

the Router’s power icon on the front panel should be on. It might take a few

minutes for the Router to fully start up.

3. Turn on your computer(s). After your computer(s) boot up, the LAN status

LED on the front of the Router will be on for each port to which a wired

computer is connected. These lights show you the connection and activity

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 38 39

Sem comentários

Buffalo Wireless-G High Speed ADSL2+ Modem Router Manual do Utilizador Página 12